After I've gathered some reference photos I decided to model this little guy and print him out. You guys can also check him out here. https://www.thingiverse.com/thing:2337962
Not too difficult. My biggest challenge was getting the joints to fit properly. It was either too tight or too loose. It was a lot of trial and error due to ABS material shrinking.
Not too difficult. My biggest challenge was getting the joints to fit properly. It was either too tight or too loose. It was a lot of trial and error due to ABS material shrinking.
I like how you articulated Stubby's arms. How difficult was that to design and set up to print?