I finished texturing and finalising the materials! :D Oh, that outline was a bit of a pain! If anyone can tell me how to set a texture not to repeat in cycles, I would be very glad! :D
However I realised after rendering that the floor on this image is above the end pin, so that's not shown! (Doh!) I cannot tell you how frustrated I was by that. I didn't re-render it as for some reason my computer goes completely dead and I have to shut down when I GPU render this (I'm pretty sure it's getting much too hot). So I had to CPU render it.. Oh well! This is as far as I'm taking it, unless I leave it to render tomorrow whilst I'm not at home.
Thanks to Mark Smith for the advice, and apologies for never showing that End Pin!
