Lately, I've been on a 3D Printing bender, so while getting models ready to print, I thought to myself, "How cool would it be if I printed out that awesome dog from the workshop?". So, I did exactly that. It took quite a few prints to get just two dogs in one piece, but well worth it.
In the picture you can see Tim "Von[n]" Rueden's concept turnaround of Johnathan Williamson's dog, the model I did in Johnathan's Mastering Modeling Workshop, and then the two dogs I printed out.
I used my Printrbot 1405 to print these, at a 0.3mm layer height, with 2.5mm supports under the head, body, and tail. The one on the left stands 2 inches tall, while the one on the right stands at 3.25 inches.
- Status: Final
No comments found.