2 answers ·
asked October 18, 2017 3:59pm
· Lesson: Sculpting the Pants · Course: Introduction to Character Modeling
it got hard to keep my mesh straight by the time i was at 5 subdivisions. especially the crease brush. it also seemed to work opposite of what was intended, even in the same stroke sometimes. like from concave to convex. suggestions?
Hmm, if it's doing the opposite double check that the brush hasn't been switched from subtract to add. Another possibility of inverted sculpting is if the normals are inverted, which can be fixed by recalculating normals in edit mode.
thanks. ive moved onto boots. im trying to power through that one. attention span strained. good series. ill check into your suggestion later though.