Excercise 1

This is an exercise submission on the exercise Mesh Modeling Exercise 01

This submission has passed!

Exercises are a great way to test what you've learned given certain restraints, while getting feedback from your peers. Plus, they're a lot of fun!

  • silentheart00

    Good job. One problem, though: the box's corners aren't correct. If you look at the video, around 1:16, the inset around the corners is a complete loop, whereas in your box it isn't the case. Probably also explains why there's a weird artifacting in the slanted corners. Your cuts aren't completely even, either, on the corner insets. Use the Loop Cut and Slide tool to set up the cuts, select the faces to extrude inward, then extrude inward. It's a good start, but there are some beginner mistakes.

  • Nestor Arellano (asoretzu)

    Well done. :)

  • bernard Delalande (somasimple)

    Good work.

  • Kees Visser (kees2357)

    Looks good, well done!

  • Christian Engvall (crillst)

    Thanks! Published it now.

  • Yves Perera (shinsaku)

    Uploading your model on Sketchfab isn't enough, you need to publish your model on Sketchfab too in order for others to be able to see it. If not it stays private.

  • Mark Smith (me1958424)

    scene not published...
    please see rule #3